Buy article online - an online subscription or single-article purchase is required to access this article.
Download citation
Download citation
link to html
Bending of 25 mm-diameter (100) silicon wafers produced by 100 nm-thick cosputtered molybdenum–silicon films has been investigated just after deposition, after rapid thermal annealing and after etching of the deposits. Values of biaxial stress in the films were determined by the use of a widely used relation. The Mo:Si ratio in the as-deposited films was 89:11. Radii of curvature of substrates were measured by a double-crystal X-ray diffractometer. Blank wafers with three widely different radii of curvature (33, 62 and 250 m) were chosen as specimens and their curvatures were taken into account in the determination of the value of biaxial stress in wafers with deposits. All the wafers were convex when viewed from the polished surface side on which the films were deposited. Values of σ for wafers with as-deposited films were in the range 3 × 108 to 14 × 108 Nm−2 (tensile). Wafers with higher initial bending showed higher values of stress. Deposition led to degradation of perfection, as revealed by broadening of the diffraction curves and the contrast in the topographs. Rapid thermal annealing at 1273 and 1373 K (3–4 min) led to formation of the MoSi2 phase and to a notable relaxation of stress. The values of σ were in the range 1 × 107 to ~6 × 108 N m−2 (tensile). The value of the stress was lowest for the blank wafer with smallest bending. Annealing also improved the degree of crystalline perfection of the silicon. Experiments performed after etching of the annealed specimens showed no significant change in the radii of curvature.

Subscribe to Journal of Applied Crystallography

The full text of this article is available to subscribers to the journal.

If you have already registered and are using a computer listed in your registration details, please email support@iucr.org for assistance.

Buy online

You may purchase this article in PDF and/or HTML formats. For purchasers in the European Community who do not have a VAT number, VAT will be added at the local rate. Payments to the IUCr are handled by WorldPay, who will accept payment by credit card in several currencies. To purchase the article, please complete the form below (fields marked * are required), and then click on `Continue'.
E-mail address* 
Repeat e-mail address* 
(for error checking) 

Format*   PDF (US $40)
In order for VAT to be shown for your country javascript needs to be enabled.

VAT number 
(non-UK EC countries only) 
Country* 
 

Terms and conditions of use
Contact us

Follow J. Appl. Cryst.
Sign up for e-alerts
Follow J. Appl. Cryst. on Twitter
Follow us on facebook
Sign up for RSS feeds